By Perth Pool Paving · Planning guidance
Start with the base and the falls
A pool surround is much more than the paver on top. Excavation, a properly compacted base, and the falls that drain splash-out and rain away from the pool and coping all sit beneath the surface — and all cost money. These are set before a rate can be treated as comparable, because a surround that drains and stays level is worth far more than a cheap square-metre price that ignores them.
The material and the coping
Travertine, limestone, porcelain and granite vary widely in supply cost, and the coping that caps the pool edge — bullnose, drop-face or square-edge — carries its own cutting and labour. Slip-rated finishes for wet, barefoot areas and sealing for porous stone are part of the figure too, so ask for each of these to be itemised rather than bundled into one rate.
Access, cutting and the extras
Getting pavers and machinery into a backyard pool area, cutting around curves, steps and the waterline, and reinstating lawn or garden edges all add hours. Confirm GST, exclusions and assumptions. No verified business pricing has been supplied, so this guide intentionally gives no dollar estimate — only what to compare.
Take this to your assessment
Bring the approximate area, photographs of the pool and surround, and a note of the side access. Ask which assumptions need a site visit, and have the agreed answers written into a clear scope so the quote reflects your actual pool, not a generic rate.
This guide supports project planning. Confirm the selected products, substrate requirements and installation instructions with the supplier.
